Advertisement
S T E P
3
A.
Install both Olympic adapter sleeves (2) as shown using:
two 23 (flat washer 10mm x 30mm)
two 26 (spring lock washer 10mm)
two 15 (round allen head 10mm x 20mm full thread bolt)
two 3 (plastic ball-end cap 2")
two 8 (rubber donut)
B.
See Note 1. Install shoulder pads (BP) and (BN) to left and right shoulder beams. Tighten pad bolts to
a snug fit. Do not over-tighten any pad bolts. Over- tightening pad bolts will cause T-nuts in pads to strip out.
Install using:
four 19 (round allen head 8mm x 90mm partial thread bolt)
four 28 (spring lock washer 8mm)
four 30 (flat washer 8mm)
C.
See Note 1. Install back pads (BR) and (BQ) in the same manner that you installed the shoulder pads.
Do NOT over-tighten any pad bolts. Install using:
four 20 (round allen head 8mm x 80mm partial thread bolt)
four 28 (spring lock washer 8mm)
four 30 (flat washer 8mm)
You should now examine the squat/calf station and make sure that all hardware
(other than upholstery hardware) is wrench tightened and secure.
Congratulations! You are done. After assembly, you should check all functions to ensure correct
operation. If you experience problems, first recheck the assembly instructions to locate any
possible errors made during assembly. If you are unable to correct the problem, call the dealer
from whom you purchased the machine or call 1-800-556-3113 for the dealer nearest you.
mm
Inch
Wrench Tighten these bolts now
7
Advertisement
