Steelcase Turnstone Conference Space Solution Set Assembly Instructions
  1. Manuals
  2. Brands
  3. Steelcase Manuals
  4. Office Equipment
  5. Turnstone Conference Space Solution Set
  6. Assembly instructions
Steelcase Turnstone Conference Space Solution Set Assembly Instructions

Steelcase Turnstone Conference Space Solution Set Assembly Instructions

Hide thumbs
1
2
3
4
5
Table of Contents

Advertisement

Quick Links

Download this manual
Conference Space - Solution Set
R
#2 ACR BIT
3/8" OPEN
END WRENCH
If you have purchased this product on Steelcase
Store, call 800.516.3454.
If you have purchased this product through an
authorized retailer, please contact them directly
or visit our website: www.steelcase.com
© 2008 Steelcase Inc.
Grand Rapids, MI 49501
U.S.A.
Page 1 of 5
Printed in U.S.A.
939500312 Rev A

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Turnstone Conference Space Solution Set and is the answer not in the manual?

Questions and answers

Related Manuals for Steelcase Turnstone Conference Space Solution Set

Summary of Contents for Steelcase Turnstone Conference Space Solution Set

  • Page 1 Conference Space - Solution Set #2 ACR BIT 3/8” OPEN END WRENCH If you have purchased this product on Steelcase Store, call 800.516.3454. If you have purchased this product through an authorized retailer, please contact them directly or visit our website: www.steelcase.com ©...
  • Page 2 BRACKET 2 PLACES 1” Rectangular APPROX. Top Version Flip the worksurfaces TIE STRAP 13” over onto a clean, APPROX. protected surface. Slide worksurfaces together. Lower two (2) tie brackets into slots (3a) and tighten in two (2) places using a 3/8" open 2 PLACES end wrench (3b).
  • Page 3 Position column legs onto worksurface as shown. NOTE: Column legs come in two (2) lengths: 27"H and 39"H. Attach each leg to worksurface by Leg to Worksurface Locations securing with twelve (12) screws. Rectangular, Racetrack & Boat-Shaped Conference Table Top - 48x120 Lower base assembly onto column leg (3a) and secure using two (2) 3/8-16 x 1-1/4"...
  • Page 4 Not included with sled base chair BACK Leather Executive Chair IMPORTANT IMPORTANT: PAY ATTENTION TO ARM ASSEMBLY (STEP 2) Attach seat to back Lay the chair back on the floor. Take care to ensure that the back will not be scratched or cut.
  • Page 5 fig. 1 fig. 2 fig. 3 Locate the four (4) holes on the chair seat (3a) and attach using four (4) 1-1/16" long hex head bolts. Push decorative cover over screw heads (3b). NOTE: After j-bar screws are tightened. Ensure all arm screws are still tight.

Table of Contents