Advertisement
®
Criterion
Arm Replacement Package
®
Torx #25 Bit
#2 PHILLIPS
#4 PHILLIPS
Bit Holder
If you have a problem, question, or request, call
your local dealer, or Steelcase Line 1 at
888.STEELCASE (888.783.3522)
for immediate action by people who want to help you.
(Outside the U.S.A., Canada, Mexico, Puerto Rico,
and the U.S. Virgin Islands, call: 1.616.247.2500)
Or visit our website: www.steelcase.com
Wave Washer
Washer
©
2003 Steelcase Inc.
Grand Rapids, MI 49501
Page 1 of 6
U.S.A.
Printed in U.S.A.
939504754 Rev C
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Steelcase Criterion
Summary of Contents for Steelcase Criterion
- Page 1 #4 PHILLIPS Bit Holder If you have a problem, question, or request, call your local dealer, or Steelcase Line 1 at 888.STEELCASE (888.783.3522) for immediate action by people who want to help you. (Outside the U.S.A., Canada, Mexico, Puerto Rico, and the U.S.
- Page 2 Arm Cap Replacement Flip the chair to an upside down position. Remove the (2) screws that are located towards the front and back edges of the arm removing the arm cap. Repeat for other side. Pay close attention to which is right and left side if doing both sides.
- Page 3 Height Width Pivot Arm Replacement Flip the chair to an upside down position. Remove the (2) screws that are located towards the front and back edges of the arm removing the arm cap. While holding the arm firmly, use a #4 phillips screwdriver or screw gun to remove the large screw with black head.
- Page 4 Gear Cover Replacement Flip the chair to an upside down position. Remove small silver screw on the underside of the arm which will be a #2 phillips drive flat head screw. Remove cover by carefully pulling in an outward motion. For old style, place new cover on slight angle and insert lip under arm cover and gently push, snapping into place being careful not to...
- Page 5 Lower Cap Replacement Flip the chair to an upside down position. While holding the arm firmly, use a #4 phillips screwdriver or screw gun to remove the large screw with black head. Repeat for other side. When doing both sides, pay close attention to which is the right and left side.
- Page 6 Arm Assembly Package Torque Tightening Pattern (Torque to 115 inch lbs.) Flip the chair to an upside down position. Remove the (3) screws holding the arm assembly in place. Remove the arm assembly. Tighten this Align the screw holes of the new arm screw 1st assembly.
Need help?
Do you have a question about the Criterion and is the answer not in the manual?
Questions and answers