Download
Share
Print this page
Steelcase Turnstone Small Office Solution Set Assembly Instructions
  1. Manuals
  2. Brands
  3. Steelcase Manuals
  4. Office Equipment
  5. Turnstone Small Office Solution Set
  6. Assembly instructions
Steelcase Turnstone Small Office Solution Set Assembly Instructions

Steelcase Turnstone Small Office Solution Set Assembly Instructions

Hide thumbs
1
2
3
4
5

Advertisement

Quick Links

Download this manual
R
If you have purchased this product on Steelcase
Store, call 800.516.3454.
If you have purchased this product through an
authorized retailer, please contact them directly
or visit our website: www.steelcase.com
© 2008 Steelcase Inc.
Grand Rapids, MI 49501
U.S.A.
Printed in U.S.A.
Small Office - Solution Set
5/16" OPEN
END WRENCH
END WRENCH
939500310 Rev A
#2 ACR BIT
5/16" DIA.
DRILL BIT
1/4" OPEN
Page 1 of 5

Advertisement

loading
Need help?

Need help?

Do you have a question about the Turnstone Small Office Solution Set and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Related Manuals for Steelcase Turnstone Small Office Solution Set

Summary of Contents for Steelcase Turnstone Small Office Solution Set

  • Page 1 DRILL BIT 5/16” OPEN END WRENCH 1/4” OPEN END WRENCH If you have purchased this product on Steelcase Store, call 800.516.3454. If you have purchased this product through an authorized retailer, please contact them directly or visit our website: www.steelcase.com ©...

  • Page 2: Caster Installation

    Lower Storage Mobile Pedestal Cabinets Caster Installation Glide Installation Turn the mobile pedestal to an upside Turn the lower down position on a storage cabinet to an clean, scratch resistant upside down position surface. on a clean, scratch resistant surface. Attach casters on Screw glides on all all four (4) corners of...
  • Page 3 CAUTION: Failure to follow the installation instructions will cause inability to install lock. PLASTIC PLUG COVER PLUG RETAINER TAB Removal of Plastic Lock Plug and Installation of Lock Cylinder Pull open plastic plug cover. TURN 90 o COIN OR HEAD OF KEY While pressing the plug retainer tab to the right, insert a coin or the head of a key into the slot and turn 90º...
  • Page 4 CENTER LINE OF DESK Make sure that the drilled holes are perpendicular TEMPLATE to the top surface to ensure that the posts assemble correctly. Cut out template. 27" Measure and mark centerline of desk with pencil. Trace the hole onto the top using a ball point pen. After you have traced all the holes needed for the Screen and Post Assembly DESKTOP...
  • Page 5 Single Post Assembly 1/4-20 BOLT SMALL WASHER TOP BRACKET POST BOTTOM BRACKET WASHER WORKSURFACE WASHER 5/16-18 BOLT Page 5 of 5 939500310 Rev A...