Checking Controller Connection - valent VPR Series Controls Instruction Operation & Maintenance

5. Select Copy every file, then select Next.
6. Select Auto-Start, then select Next.
7. Select Reboot the remote host, then select
Next.
8. Select Finish.
9. A pop-up indicates that the existing station is
being shut down. This screen automatically
closes when the shutdown is complete.
WARNING:
Clicking on the Abort button cancels the station
transfer and could damage the internal software.
Do not press Abort unless instructed by the
factory.
Valent Controls IOM
10. When the file transfer is complete, select
Close.
The controller automatically reboots. Allow
several minutes to finish.
11. Disconnect from the controller and
reconnect if desired.

Checking Controller Connection

A ping test can be used to check the connection
from the controller to the UMT or to check the
communication status at any time. The ping test
is run from Command Prompt window.
Locating Command Prompt Window from Windows XP
1. Click on the start menu.
2. Select the Run icon. A pop-up box appears.
3. Enter cmd at the prompt and click on OK to
open the Command Prompt window.
4. Perform the Ping Test as described later in
this section.
61 IOM-C1-0616
Part Number 474626