Station - valent VPR Series Controls Instruction Operation & Maintenance

1. Select the TCP/IP Configuration tab.
2. Expand Interface 1 by clicking on the double
arrows to the right of the title.
IMPORTANT:
Do not change the parameters for Interface
2.
3. Edit the Gateway, IP Address, and Subnet
Mask as required, then click on Save
TCPIP.
IMPORTANT:
Do not select Enabled for DHCP; this can
make the controller difficult to access.
Valent Controls IOM
4. A pop-up message asks for confirmation to
reboot the controller. Select Yes.
5. A pop-up message confirms that the
controller is rebooting. Select OK. Allow
several minutes for the controller to reboot.
6. Disconnect from the controller and
reconnect if desired.
IMPORTANT:
When the IP Address has been changed, the
controller can only be accessed by connecting
through the new address. If the address is lost
or forgotten, the controller may not be
accessible. Before rebooting, record the new
controller address in a convenient location.

Station

Checking Unit Status
Select the Unit Status tab to see a summary of
the temperature inputs to the unit controller.
17 IOM-C1-0616
Part Number 474626