Reviewing Lonworks Settings - valent VPR Series Controls Instruction Operation & Maintenance

Reviewing LonWorks Settings

The LonWorks settings for the JENEsys
controller are available in the
the LCD display. To access them:
1. Push any button on the LCD interface to
refresh the display. If the main menu is not
shown, press the
MENU
main menu.
2. Press Enter to select
STATUS menu is the first menu displayed.
3. Press the right arrows below
the last tab of the points menu, which is for
COMMUNICATIONS .
4. Use ▼ to scroll down to reach the LonTalk
points.
LonTalk is an optional feature which must be
licensed. Although data will appear for viewing
on the communications menu, settings cannot
be changed if the unit has not been licensed.
Valent Controls IOM
menu of
POINTS
button to return to the
POINTS . The UNIT
LAST to jump to
COMMUNICATIONS
BAUDRATE
MAX MASTERS
MAX INFO FRAMES
****LONTALK
NID
SERVICE PIN
MENU PREV
Service Pin
The SERVICE PIN
the Valent unit on the building's LON network.
1. On the LonWorks menu, navigate to
SERVICE PIN .
2. Press Enter to make the point editable.
Toggle ▲ or ▼ to make the value
then press Enter. This sends a service pin
signal over the LON network. This can be
repeated as many times as necessary.
Using LonTalk Communications
Refer to
for further information about LonTalk
communications.
10
9600
127
20
*****
04 1E 0F E8 03 00
FALSE
NEXT LAST
is available to help discover
TRUE
on page 25
IOM-C1-0616
Part Number 474626
,