Melitta Solo & Perfect Milk Operating Instructions Manual page 9

Preparing milk froth
If possible, use cold milk with a high
protein content.
■ Switch on the device.
■ Submerse the Cappuccinatore hose 13
directly into the milk.
■ Press the
button.
the appliance is heating up. After the
heat-up phase,
■ Turn the control dial (Image F, 3) to the
"Milk froth" position (
■ Turn the valve switch 11 clockwise until
the stop. is fl ashing. The milk froth is
being prepared.
■ Turn the valve switch 11 anticlockwise
until it stops.
The preparation is fi nished.
■ Rinse the Cappuccinatore after
each use.
Heating milk
■ Switch on the device.
■ Submerse the Cappuccinatore hose 13
directly into the milk.
■ Press the
button.
the appliance is heating up. After the
heat-up phase,
■ Turn the control dial (Image F, 3) to the
"Warm milk" position (
■ Turn the valve switch 11 clockwise until
it stops. is fl ashing. The milk is being
heated.
■ Turn the valve switch 11 anticlockwise
until it stops. The heating is completed.
■ Rinse the Cappuccinatore after
each use.
Operating Instructions: Melitta
fl ashes while
is illuminated.
is pointing up).
fl ashes while
is illuminated.
is pointing up).
® ®
Solo & Perfect Milk | 1830-0618 | 2018-08
Rinsing the Cappuccinatore
The Cappuccinatore should be cleaned
at regular intervals ("Cleaning the
Cappuccinatore", page 25).
It is recommended to rinse the
Cappuccinatore on a weekly basis with
®
the Melitta PERFECT CLEAN milk
system cleaner. Use the milk cleaning
solution instead of clear water.
■ Switch on the device.
■ Fill a vessel halfway with clear water.
■ Hold a vessel under the Cappuccinatore.
The hose of the Cappuccinatore must be
submersed in the water.
■ Press the
button for steam
dispensing.
■ Turn the control dial (Image F, 3) to the
"Milk froth" position (
■ Turn the valve switch 11 clockwise until
it stops. Close the valve switch when
a mixture of clean water and steam
comes out.
■ Wait for 30 seconds or press the
button to change to the normal operating
mode.
Dispensing hot water
A maximum of 150 ml of hot water can be
dispensed in each process. To dispense
a larger amount of hot water, repeat the
process.
■ Switch on the device.
■ Turn the control dial (Image F, 3) to the
"Hot water" position (
■ Hold a vessel under the Cappuccinatore.
■ Turn the valve switch 11 clockwise until
the stop. is fl ashing. Hot water will
fl ow into the vessel.
■ Turn the valve switch 11 anticlockwise
until it stops.
Preparation
is pointing up).
is pointing up).
23