Melitta Solo & Perfect Milk Operating Instructions Manual page 8

Preparation
■ Fill the water tank with fresh tap water
only up to the max. mark.
■ Insert the water tank into the appliance.
■ Place a vessel under outlet 2.
■ Press the on/off
appliance on or off. The appliance may
perform an automatic rinse.
Preparation
■ Fill the water tank with fresh water every
day. The water tank must always be
fi lled with enough water for the operation
of the appliance.
■ Fill the bean container preferably with
espresso beans or bean mixtures for
fully automatic coffee machines.
Do not use any ground, glazed,
caramelised, or otherwise sugar-coated
coffee beans.
Setting the dispensed quantity and
strength
■ Turn the coffee quantity regulator 4 to
infi nitely adjust the dispensed quantity.
Regulator all the way to the left
= 30 ml per cup
Regulator all the way to the right
= 220 ml per cup
■ Press the
strength is adjusted. The strength is
shown by the beans on the display 10
(from = mild to
22 Operating Instructions: Melitta
button to turn the
button until the desired
= strong).
Dispensing coffee or espresso
One or two cups can be dispensed
simultaneously.
■ Switch on the device.
■ Place one or two cups under the outlet.
■ Preparing one cup: Press the
button once.
■ Preparing two cups: Press the
button twice.
■ Press the button again to cancel the
coffee dispensing.
Preparing milk froth and heating
milk and water
WARNING
There is a risk of burn injuries and
scalding due to hot steam and the
hot steam pipe!
▶ Never reach into the escaping steam.
▶ Avoid direct skin contact with hot water
and the hot steam pipe.
▶ Never touch the steam pipe during
use or immediately after use.
The Cappuccinatore is used to prepare
milk froth, to heat milk or to dispense hot
water.
It can froth the milk directly from the milk
carton or a vessel into the cup.
You can optionally connect it to a
Melitta ® milk container.
® Solo ® & Perfect Milk | 1830-0618 | 2018-08