Other Settings - Melitta Solo & Perfect Milk Operating Instructions Manual

Descaling phase 1 (
■ Empty and reinsert the drip tray.
■ Place the coffee grounds container
under the Cappuccinatore.
■ Turn the control dial (Image F, 3) to the
"Hot water" position (
illuminates.
■ Completely empty the water tank.
■ Add the descaling agent to the water
tank according to the instructions on the
packaging.
■ Insert the water tank.
■ Press the
button to start the
descaling programme (takes about
15 minutes).
Descaling phase 2 (
When illuminates, proceed as follows:
■ Ensure that the coffee grounds container
is placed under the Cappuccinatore.
■ Turn the valve switch 11 clockwise until
the stop. is fl ashing. Water will fl ow
intermittently into the coffee grounds
container (takes about 10 minutes).
is then illuminated.
■ Empty the drip tray and coffee grounds
container.
■ Reinsert the drip tray and put the coffee
grounds container back under the
Cappuccinatore.
■ Remove the water tank and rinse
thoroughly with clear water.
■ Fill the water tank with tap water up to
the max. mark.
■ Insert the water tank.
■ Press the
button to continue with the
descaling programme.
Water fl ows into the coffee grounds
container.
Operating Instructions: Melitta
):
is pointing up).
):
illuminates.
is fl ashing.
® ®
Solo & Perfect Milk | 1830-0618 | 2018-08
Descaling phase 3 (
When illuminates, proceed as follows:
■ Turn the valve switch 11 anticlockwise
until it stops.
Water fl ows inside the appliance into
the drip tray.
■ When
is illuminated, empty the drip
tray and the coffee grounds container
and reinsert them. When
illuminated, the descaling programme
is fi nished.
■ Insert the water fi lter if necessary
("Water hardness and fi lter", page 24).

Other settings

Energy-saving mode
After the last action, the appliance
switches automatically (depending on
the settings) to the energy-saving mode.
From the factory, the appliance is set at
5 minutes .
■ Switch on the device.
■ Press the
and
simultaneously until
■ Press the
button twice.
illuminates.
■ Press the
button until one of the four
times is set. The time is displayed by the
beans on display 9.
Display
fl ashing
■ Press the
button to confi rm the
setting.
Other settings
):
is
buttons
fl ashes.
Time
5 minutes
(factory setting)
15 minutes
30 minutes
off
27