Melitta Solo & Perfect Milk Operating Instructions Manual page 16

Transport, Storage and Disposal
Malfunction
Coffee only fl ows drop-by-
drop.
Coffee does not fl ow.
The grinder is not grinding.
Loud grinder noise.
Bean symbols
fl ashing although the bean
container is full.
Appliance indicates "no
water" even though the water
tank is fi lled.
illuminates on the
display.
The symbol is illuminated
without a reason.
The cleaning or descaling
process was interrupted.
Not enough milk froth is
formed during the frothing
process.
The brewing unit can no
longer be reinserted after
removal.
30 Operating Instructions: Melitta
Troubleshooting
Grinding fi neness is too
fi ne.
Water tank not fi lled or
incorrectly inserted.
The brewing unit is clogged. Clean the brewing unit.
The beans are not falling
into the grinder.
Foreign objects in the
grinder.
Foreign objects in the
grinder.
Insuffi cient quantity of
are
ground beans in the
brewing chamber.
The fl oat is blocked.
There is air in the lines
inside the appliance.
The power supply was
interrupted, e.g. due to a
power outage.
The control dial of the
Cappuccinatore is in the
wrong position.
The Cappuccinatore is dirty.
The brewing unit is not
properly locked.
The actuator is not in the
proper position.
Cause
Adjust the grinding fi neness more
coarse.
Clean the brewing unit.
Perform a descaling or cleaning
programme if necessary.
Fill the water tank and make sure it
is properly inserted.
Tap lightly on the bean container.
Call the hotline.
Call the hotline.
Press the
button.
Check the condition of the fl oat in
the water tank, remove the water
and carefully shake the tank.
Turn the valve switch 11 clockwise
until the stop until water fl ows out of
the appliance.
Clean the brewing unit if necessary.
The appliance performs a rinsing
program autonomously. To do
so, follow the instructions on the
appliance.
Adjust to the proper position.
Take the Cappuccinatore apart and
clean it.
Check whether the handle for
locking the brewing unit is correctly
engaged.
Switch the appliance off and
then on again. Press the
and
for longer than 2 seconds. The
actuator is put into position. Then
reinsert the brewing unit and make
sure it is correctly locked into place.
® Solo ® & Perfect Milk | 1830-0618 | 2018-08
Measure
button or
buttons simultaneously