Peripheral/Option Checks; Input Power; Mains Cable Inspection; Cleaning - GE LOGIQ 180 Basic Service Manual

GE M S
EDICAL YSTEMS
D 2317229, R
IRECTION EVISION
10-5-2-2

Peripheral/Option Checks

If any peripherals or options are not part of the system configuration, the check can be omitted. Refer
to the User Manual for a list of approved peripherals/options.
Table 10-39 GE Approved Peripheral/Hardware Option Functional Checks
Step
1
2 VGP Printer Verify hardcopy output of the video graphic printer. Clean heads and covers if necessary.
3
4
10-5-3

Input Power

10-5-3-1

Mains Cable Inspection

Table 10-40 Mains Cable Inspection
Step
1 Unplug Cord Disconnect the mains cable from the wall and system.
2
3
4
10-5-4

Cleaning

10-5-4-1

General Cleaning

Table 10-41 General Cleaning
Step
1
2 Probe Holder Clean probe holders. (they may need to be soaked to remove excess gel).
3
Item
VCR
Verify record/playback capabilities of the VCR. Clean heads and covers if necessary.
B/W Printer Verify hardcopy output of the B/W printer. Clean heads and covers if necessary.
Footswitch
Verify that the footswitch is functioning as programed. Clean as necessary.
Item
Inspect
Inspect it and its connectors for damage of any kinds.
Verify that the LINE, NEUTRAL and GROUND wires are properly attached to the terminals, and that
Verify
no strands may cause a short circuit.
Verify
Inlet connector retainer is functional.
Item
Use a fluid detergent in warm water on a soft, damp cloth to carefully wipe the entire system. Be careful
Console
not to get the cloth too wet so that moisture does not enter the console.
Chapter 10 Quality Assurance
LOGIQ™ 180 B
ASIC
Description
Description
Description
S M
ERVICE ANUAL
10 - 7