Sample Period; Duplex Mode - Fluke 7060 User Manual

7060/7061
User's Guide
9.12.2
9.12.3
48
1200 b Current baud rate
The baud rate of the bath serial communications may be programmed to
300,600,1200, or 2400 baud. Use "UP" or "DOWN" to change the baud rate
value.
2400 b New baud rate
Press "SET" to set the baud rate to the new value or "EXIT" to abort the op-
eration and skip to the next parameter in the menu.

Sample Period

The sample period is the next parameter in the serial interface parameter
menu. The sample period is the time period in seconds between tempera-
ture measurements transmitted from the serial interface. If the sample rate
is set to 5, for instance, then the bath will transmit the current measurement
over the serial interface approximately every five seconds. The automatic
sampling is disabled with a sample period of 0. The sample period is indi-
cated by,
SAmPLE Serial sample period parameter
Press "SET" to choose to set the sample period. The current sample period
value will be displayed.
SA= 1 Current sample period (seconds)
Adjust the value with "UP" or "DOWN" and then use "SET" to set the sample
rate to the displayed value.
SA= 60 New sample period

Duplex Mode

The next parameter is the duplex mode. The duplex mode may be set to full
duplex or half duplex. With full duplex any commands received by the bath
via the serial interface will be immediately echoed or transmitted back to
the device of origin. With half duplex the commands will be executed but
not echoed. The duplex mode parameter is indicated by,
dUPL Serial duplex mode parameter
Press "SET" to access the mode setting.
dUP=FULL Current duplex mode setting