Step 2 - Testing Blood Glucose - Acon On Call ExtraMobile User Manual

Step 2 – Testing Blood Glucose
Note: Insertion of a new test strip at any time, except while in the data transfer mode
(See page 29) will cause the meter to automatically enter the test mode.
1. Insert a test strip into the strip port, contact bars end first and facing up. This
will turn on the meter and display all the display segments. If the audio option is
on, the meter will beep when the meter is turned on.
2. Check the display to confirm that all the display segments turn on with no
missing components. The display will then show only the date and time, with a
dash moving across the display. Check the display to ensure no inappropriate
segments or icons are permanently turned on.
NOT READY
3. Following this display check, the system will enter the test mode. The display
will show the date and time, and the strip icon with the blood sample icon
blinking, to indicate that the test strip is inserted correctly and that a drop of
blood can be added. If the test strip has been inserted incorrectly, the meter will
not turn on. The meter is ready for testing when the blinking blood drop and strip
symbol appears. At this time a blood drop can be added.
4. Touch the blood drop to the sample tip at the end of the test strip. If the audio
option is turned on, the meter will beep to indicate that the sample is sufficient
and the measurement has started. If you applied a drop of blood, but do not see
the countdown begin, you may reapply a second drop of blood within 3 seconds.
DO NOT:
 Apply the sample to the front or back of the test strip.
 Smear the blood drop onto the test strip.
 Press your finger against the test strip.
NOT READY
READY TO TEST
23
NOT READY