A.R.I. D-040 L ARISENSE Installation Operation & Maintenance page 41

41 IOM D-040 L ARISENSE
8.2.4. Cleaning and inspecting the float components
• Thoroughly wash and clean the air valve components under clean running water to remove all grime; Pay special
attention to the internal parts.
• Visually check the condition of the Rolling Seal [1] & [2]. If any cracks or tears are found remove it from the Float
and replace it.
1
2
If replacement is necessary, slide out and remove the Rolling Seal Assembly [3]
Take a new Rolling Seal Assembly and dip the tail end into the liquid soap solution [4]
3
4