Table of Contents
Advertisement
PAGE 21
Installation Instructions (Continued)
Option B: Connecting to a standpipe
CONNECTION OF THE DRAIN HOSE (continued)
The standpipe must be a minimum diameter of 38mm (1 1/2 inch) and requires a trap
for odor control.
Option B: Connecting to a standpipe
The standpipe must be a minimum diameter of 38mm (1 1/2 inch) and requires a trap for odor
Use the hose support clip to secure the hoses, ensure they do not enter the standpipe
control. Use the hose support clip to secure the hoses, ensure they do not enter the standpipe
more than 120mm.
more than 120mm.
NOTE:
NOTE:If there is surplus length of the drain hose it can be shortened. The Inlet Hose cannot be
If there is surplus length of the drain hose it can be shortened. The Inlet Hose
shortened.
cannot be shortened.
Whilst the very first wash cycle is operating, observe all pipe and hose connections for leaks.
Whilst the very first wash cycle is operating, observe all pipe and hose connections
Checking for any trace of water on the floor in the cavity where the connections are after the
first full cycle is a good practice.
for leaks. Checking for any trace of water on the floor in the cavity where the
connections are after the first full cycle is a good practice.
120mm maximum entry
Standpipe ∅38
mm minimum
INALTO.HOUSE
Advertisement
Table of Contents
