Table of Contents
Advertisement
PAGE 13
Using Your Dishwasher (Continued)
ADJUSTING THE RINSE AID DISPENSER
To achieve the best drying result, with the
least amount of rinse aid being used, the
dispenser can be adjusted by the user.
There are 5 levels of adjustment, the factory
setting is D3. This setting will provide excellent
drying results.
If the dishes are not drying properly or with
cloudy stains, the setting of D4 or D5 will be
required.
If there are sticky whitish stains on your dishes
or a bluish film on glassware or knife blades,
the dispenser can be set back to either D2
or D1 to reduce any unnecessary waste of
rinse aid, whilst maintaining excellent drying
results.
Follow the steps below:
1.
Switch on the dishwasher by press the
Power button.
2.
Within 60 seconds after step 1, press the
Start/Pause button more than 5 seconds,
the rinse aid indication blinks.
3.
Press the Start/Pause button to select the
proper set according to your using habits,
the sets will change in the following
sequence: D1->D2->D3->D4->D5->D1.
4.
Without any operations in 5 second, or
exit the set mode through the power
button, the new setting is active.
INALTO.HOUSE
Advertisement
Table of Contents
