Basic Programming - YASKAWA GPD-506V Technical Manual

4 . 3 B A S I C PROGRAMMING
By using the Quick-Start Displays on the Digital Operator, simple programming of the drive
is possible. Following are examples of two methods for setting the acceleration time
( n 0 1 8 ). The first example shows how to utilize the A c c e l Quick-Start Display, and the
second example shows how to access parameter n 0 1 8 through the Program Mode.
EXAMPLE 1: Using Accel Quick-Start Display
• Press the DSPL key repeatedly until the " Accel Time 1 "
appears.
• To set the acceleration time to 5 seconds, press the "down
arrow" key until the Digital Operator display reads " 5.0 ".
• Press the ENTER key.
EXAMPLE 2: Using Program Mode
• Press the DSPL key repeatedly until " Parameter n001 "
appears.
• Press the "up arrow" key to access n 0 1 8 .
• Press the ENTER key. The current set value is displayed.
• To set the acceleration time to 15 seconds, press the "up
arrow" key until the Digital Operator display reads " 15.0 ".
• Press the ENTER key.
Note: Once changed, data will blink until the
ENTER key is pressed.
• Press the DSPL key until " Frequency Ref " appears
and DRIVE LED turns on.
4-5
Display
Accel Time 1
10.0 sec
Accel Time 1
5.0 sec
Accel Time 1
5.0 sec
Parameter n001
Password
Parameter n018
Accel Time 1
Accel Time 1
10.0 sec
Accel Time 1
\ | /
15.0 sec
Accel Time 1
15.0 sec
Frequency Ref
0.0 Hz