Advantage Controls 200 Series Manual page 21

SETPOINT
122
123
124
125
126
127
128
129
130
131
132
133
DESCRIPTION
FLUSH MODE - Determines the operation of
the inlet valve and RO pump during flush.
FLUSH TIME - Length of flush cycle.
FLUSH INTERVAL - Selects the interval
between flushes when an interval type of
flush is selected.
LO PSI DELAY - Delay before an active
low pressure switch will cause a shutdown.
HI PSI SW DELAY - Delay before an active
high pressure switch will cause a shutdown.
AUX MODE - If set to 0, relay 4 operates as
auxiliary pump control.If set to 1, relay 4
operates as a boost pump control.
SA1 - Selects active sensors for data logging.
SA2 - Selects active sensors for data logging.
SA3 - Selects active sensors for data logging.
SA4 - Selects active sensors for data logging.
UOM - Selects unit of measure for data logging.
warning. If set to 0, warning is disabled.
PTL Boost Enable
21
RANGE DEFAULT
0-4 0
0-99 min. 5
0-99 hrs. 24
0-99 sec. 5
0-99 sec. 5
0-1 0
0-255 0
0-255 0
0-255 0
0-255 0
0-255 0
0-1 0