Hdd Status Leds - Barco Thor Series User Manual

Hide thumbs Also See for Thor Series:
Table of Contents

Advertisement

5.6 HDD status LEDs

HDD status LEDs
Image 5-15
4
HDD I/O LED
5
RAID LED
Status LEDs on ICMP(-X)
HDD I/O
RAID
Off
Off
Blinking green
Off
Blinking green
Slow blinking
red
Blinking green
Fast blinking
red
Off
Red
When entering a new HDD in an ICMP(-X), the HDD RAID LED will be full red for a short time. This
is not an error, the HDD has not yet been "recognized" by the projector and ICMP(-X).
Once the HDD has been accepted by the ICMP(-X), the full red LED will start blinking in accordance
with the previous status table.
If the LED remains full red, an error has occurred. In this case, consult the following troubleshooting
table for curative actions.
Troubleshooting
Situation
One disk failed (red LED) + RAID degraded.
The ongoing event is not interrupted.
Note: The disk status (RAID degraded) can be
retrieved via the (Web) Commander. See user guide
of the (Web) Commander.
One disk failed (red LED) + Error 10580 "local
storage not available".
Note: The disk status (Error code) can be retrieved
via the (Web) Commander. See user guide of the
(Web) Commander.
HDD Status
HDD idle / disk in RAID OK.
HDD I/O activity / disk in RAID OK.
HDD disks not (yet) initialized (not supported on ICMP with GEN1 storage
controller).
HDD I/O activity / RAID rebuilding.
HDD idle / Disk error. Consult the following troubleshooting table for
curative actions.
Solution
1.
Switch off the power.
2.
Replace the defect HDD with approved model of
the same storage capacity. See procedure
"Removing a HDD from the ICMP(-X)", page 46,
and "Installing a HDD into the ICMP(-X)", page
44. Ensure to insert the HDD firmly.
3.
Switch on the power.
Result: As soon the new HDD is detected by the
ICMP(-X) the rebuild of the RAID is started (Blinking
red LED).
1.
Switch off the power.
2.
Replace the defect HDD with approved model of
the same storage capacity. See procedure
"Removing a HDD from the ICMP(-X)", page 46,
and "Installing a HDD into the ICMP(-X)", page
44. Ensure to insert the HDD firmly.
ICMP(-X)
R5906787 /04
Thor series
47

Advertisement

Table of Contents
loading

Table of Contents