Whirlpool WVMD1208AHG Service Manual page 6

d. Drain
Water does not
drain out.
TROUBLE
Drain takes time too
long.
Note: In draining, the water level sensor can Note: In draining, the water lever sensor can
not reset in 8minutes. not reset in 8 minutes.
The number window LED display The number window LED display
abnormal code: abnormal code:
on and off at the same time and the on and off at the same time and the
electric buzzer sounds to indicate a electric buzzer sounds to indicate a
problem. problem.
• If the Drain Hose is too long or high, water may overflow during
the rinsing cycle or make rinsing or draining impossible.
• The built-in pump is capable of discharging water to a maximum
height of 1.0 meters and minimum height of 0.7 meters.
• The pump makes a noise at the starting.
If you want to reduce the noise, please raise the opening end of
the Drain Hose above the floor 1 meter or more.
The pump makes an idling noise during washing.
This is normal.
e. Spin Drying
Spin drying cycle
does not work.
No
Brake lining is worn out.
Brake lever ass
Yes
Foreign matter in drain hose.
No
Pump lead wire is
disconnected.
Control circuit board is
defective.
INSPECTION INSPECTION INSPECTION
Drain hose ass
Hose is connected in the
wrong way.
Hose is too long or position of
and begin blinking and begin blinking
Is the built-in
pump working
normally？
Yes
Does safety Machine inclines.
device work?
No
The V-belt is slipping.
The V-belt is snapped.
Small pulley mounting
screw is loosed.
'
y is defective.
CAUSES
'
y is deformed.
hose is too high.
6
'
Replace bearing ass y.
'
Replace bearing ass y.
Clean drain hose
inside.
Repair or replace.
Replace.
REMEDY
Repair or replace.
Repair.
Repair.
Replace with level.
Adjust the motor
position.
Replace.
Tighten up.