Whirlpool WVMD1208AHG Service Manual page 5

Note: When removing the flow sheet, reinstate the filter in place correctly.
Water does not stop
TROUBLE
c. Wash/Rinse
Washing cycle does
not start even if
water keeps the
selected water level.
The spin tub rotates
together with the
pulsator during
washing or rinsing
cycle.
Note:
Brake-work is
normal when spin
tub stops within 10
sec. under no-load.
Does water stop
when the plug
is removed or
Yes
power switch is
OFF?
No
Does the pulsator
rotate by hand?
Does humming
noise come on
from motor?
INSPECTION INSPECTION
No
Is the torque motor
Does the spin tub
working normally?
rotated normally
when the
COURSE button
is set to SPIN?
Yes
No
Does brake-work
normally?
Yes
No
Yes
Yes
No
Something in the air trap
hose or air leaks from a
part related water level
sensor system.
Water level sensor is
defective.
Control circuit board is
defective.
Something on the
diaphragm on the water
valve.
Diaphragm is deformed
The height of drain hose is
less than 0.7m.
CAUSES
'
Bearing ass y is defective.
Poor connect of 6-pin
connectors (blue & white)
Thermostat on motor is
opened.
Control circuit board is
defective.
'
Bearing ass y is defective.
Motor wires are
dis-connected.
Capacitor wires are
dis-connected.
Capacitor is defective.
Motor coil shorten.
'
Brake lining on bearing ass y
is worn out.
'
Brake lever ass y is defective.
Torque motor is broken.
5
Clean or replace.
Replace .
Replace.
Replace or
disassemble the
valve and clean
the diaphragm
Replace
Make the height of
drain hose is not less
than 0.7m.
REMEDY
Replace.
Replace.
Repair or replace
after cooling down.
Replace.
Replace.
Replace or repair.
Replace or repair.
Replace.
Replace.
'
Replace bearing ass y.
'
Replace bearing ass y.
Replace.