Whirlpool WVMD1208AHG Service Manual page 8

stop Spin-Dry cycle and operates water supply valve to pour water into the Wash/Spin Tub and
then starts washing cycle for replacing washing clothes evenly.
After above operation has down twice, if safety device works again, machine will stop, and the
number window LED display abnormal code:
and the electric buzzer sounds to indicate a problem.
• Open the Wash Lid and rearrange the clothes evenly around the Wash/Spin Tub.
• Close the Wash Lid and press the START/PAUSE button again.
f. Buzzing and rattling
Buzzing/rattling
during water
supply.
TROUBLE
Buzzing/rattling
during washing
or rinsing.
Buzzing/rattling
during spin-dry.
Low
Is high water
INSPECTION INSPECTION
pressure (more
2
than 4kg/cm )?
High
INSPECTION INSPECTION
Does some noise
Yes
sound during
spin drying?
No
Is sound in
low-pitched
monotone?
Is variable sound
happened by
vibration?
Does noise sound
when the washer
begins to work?
Is clattering on
maximum
rotation?
Is flapping?
and begin blinking on and off at the same time
Something in water valve.
Faucet open too far
CAUSES
Belt is slipping.
Pulley is loose.
Some part touch motor
Something underneath
pulsator.
Pulsator is rubbing.
Pulsator shaft is burnt.
Bearings of bearing ass
is defective.
Machine is in unbalance.
'
Suspension rod ass y is
worn out.
Belt is slipping
Motor pulley is loose.
Wire and/or air trap hose
is loose.
8
Replace.
Adjust faucet
turning.
REMEDY
Adjust.
Tighten.
Repair or replace
Remove.
Adjust bearing ass
Replace bearing ass
'
y Replace.
Place machine
evenly on base.
Replace.
Adjust.
Tighten up.
Tighten.
'
y.
'
y.