Dpccontrol - Toshiba teli BU Series Instruction Manual

DPCControl

This DPC (Defective Pixel Correction) function corrects defective pixels from the image sensor. Specifying X
and Y coordinates of the defective pixels, the defective pixels are corrected by calculation from the neighboring
pixels.
● Registers
Register Visibility
DPCEnable Expert
DPCNumber Expert
DPCIndex Expert
DPCEntryX Expert
DPCEntryY Expert
● Setting
- Set the activation of DPC
Set the following value to "DPCEnable" register. The setting value is Boolean type.
- Set the coordinates of defective pixels
Set the number of pixels to correct to "DPCNumber" register.
Then, set the index number for entry to "DPCIndex" register, and coordinates of defective pixels to
"DPCEntryX", "DPCEntryY" register. After setting coordinates, the defective pixel is corrected by
calculation from the neighboring pixels. In the case that there is a number of defective pixels, they can be
corrected by pointing new DPCIndex and setting coordinates
Minimum
Maximum
Copyright © 2015 - 2019 Toshiba Teli Corporation, All rights reserved.
Access
R/W Sets the activation of DPC function.
R/W Sets the number of pixels to correct.
R/W Sets the index number for entry.
R/W Sets the X coordinate of defective pixel.
R/W Sets the Y coordinate of defective pixel.
setting value
OFF (*)
ON
DPCNumber DPCIndex
0 0
256 255
70 / 74
Description
function
Inactive
Active
* initial factory setting
DPCEntryX DPCEntryY
0
WidthMax-1 HeightMax-1
0
D4245116F
http://www.toshiba-teli.co.jp/en/