Connection - Toshiba teli BU Series Instruction Manual

Cmos color camera

Hide thumbs Also See for BU Series:

Table of Contents

Connection

Camera

(Mirco B)

(e-CON)

Camera mounting unit

CPTBU, CPTBUBG

Notes on Connection:

- Please confirm the power supply of the camera off when plugging in or pulling out the I/O Connector. It causes the

breakdown.

- If your camera is used in a system where its connectors are subjected to strong repetitive shocks, its connectors are

possible to break down. If you use your camera in such a situation, use an USB3.0 cable with a lock screw, and secure

the camera cable as close as possible to the camera body for avoid physical shock to the camera connector.

- About e-CON cable: In the case that electric-wire is long or thin, input and output voltage may not satisfy specifications

of the camera or your system by voltage drop. Please confirm wires' specifications before use them.

Lost packets may occur by an electrical characteristic of the transmission line of USB3.0. (USB3.0 Interface Card,

USB3.0 Cable, and USB3.0 HUB).

USB3.0 Cable

Control Packet

Stream Packet

e-CON Cable

1. GPIO IN/OUT

2. GPIO OUT

3. GND

4. TRIG IN

(Standard A)

Interface Card

15 / 74

Host(PC etc.)

D4245116F

http://www.toshiba-teli.co.jp/en/

Table of Contents

Bu1203mc Bu1203mcf