Toshiba MMY-SAP0806HT8P-E Service Manual page 215

N . o P a t r o t b e e r p a l c e d
8 Pipe fixing rubber
- detachment/
attachment
(common)
1. Detachment
2. Attachment
W o k r p o r c e d
WARNING
Wear a pair of gloves.
Otherwise, you will risk an injury involving a
replacement part or some other object.
1) Hold the pipe fixing rubber in such a manner that
your fingers and thumb are in contact with the two
longitudinal ends of the piece, and squeeze it a
little to create a small gap between the rubber and
the stainless steel band wrapped around it.
2) Push the hook end of the stainless steel band
down to disengage the hook from the square
hole.
1) The pipe fixing rubbers use a two-segment design
to accommodate a wide range of pipe
combinations. When installing them, therefore, it
is recommended to first split them up into
segments and pair the segments up only after
placing them on pipes of matching sizes
separately. In this regard, make sure that the
mating tooth and slit of pairing segments face
each other.
2) When placing an stainless steel band around
pipe fixing rubber, make sure that the hook end
of the stainless steel band coincides with the slit
side of the rubber.
(The band can be placed the other way around,
but only at the expense of work efficiency.)
3) Place the stainless steel band tightly around the
pipe fixing rubber so that there is no gap
between them.
Take utmost care not to create a gap over the
curved section of the rubber where the hairpin
side of the band is located.
4) While holding the rubber, press down the base of
the hook lightly against the rubber, and engage
the hook with the square hole by squeezing the
curved section of the rubber where the square
hole side of the band is located (see the arrow).
(If the hook does not engage with the square hole,
recheck whether there is a gap between the band
and rubber.)
u e r
1)
Squeeze rubber to create small gap.
2)
Push band down in arrow direction.
Place two segments of damper on pipes of
matching sizes separately, making sure tooth and
slit of pairing segments face each other.
1)
2)
3)
Push square hole end of tape in
arrow direction by squeezing rubber.
Press down hook side of
tape against rubber.
- 215 -
R e m a k r s
Align tooth and slit and push two
segments towards each other.
Make sure that hook end of stainless steel
band coincides with slit side of rubber.
Slide it along.
Place band tightly around rubber
without a gap between them.
4)