Flow Selector unit Single-port type (hereafter "Flow Selector unit") Thank you very much for purchasing TOSHIBA Super Heat Recovery Multi Advance (SHRM-A) Air conditioner. Please read this manual carefully before using your Flow Selector unit. • When installing an indoor or outdoor unit, follow the Installation Manual supplied with the unit.
PRECAUTIONS FOR SAFETY Accessory parts and Parts to be procured locally Accessory parts • Ensure that all Local, National and International regulations are satisfi ed. Q'ty RBM- Part name Shape Usage Y1121FUPE Y1801FUPE Y2801FUPE • Read this “PRECAUTIONS FOR SAFETY” carefully before This manual for installer.
Page 4
Meanings of symbols in this manual This mark is for R32 refrigerant These safety cautions describe important matters concerning only. Refrigerant type is written on safety to prevent injury to users or other people and damages to nameplate of outdoor unit. property.
Page 5
• To avoid personal injury (with sharp edges), be careful when WARNING handling parts. • Ask an authorized dealer or qualifi ed installation • Perform installation work properly according to the professional to install/maintain the air conditioner. Installation Manual. Inappropriate installation may result in water leakage, electric Inappropriate installation may result in water leakage, electric shock or fi...
SELECTION OF INSTALLATION PLACE • Use the specifi ed wires for wiring connect the terminals securely fi x. To prevent external forces applied to the terminals from CAUTION affecting the terminals. Do not install the air conditioner at place where combustible gas may leak. If gas leaks is collected at surrounding the unit, the production of fi...
Page 7
Installation under high-humidity atmosphere <Installation space> (Unit : mm) In some cases including the rainy season, especially inside of the ceiling may become high-humidity atmosphere. 1. Installation to inside of the ceiling with tiles on the roof Bolt size : M10 or Ø3/8 (fi...
INSTALLATION OF FLOW SELECTOR Installation of hanging bolt Use M10 hanging bolts (3 pcs, locally procured). UNIT Matching to the existing structure, set pitch according to size in the unit external view as shown below. New concrete slab Install the bolts with insert brackets or anchor bolts. WARNING Rubber Install the unit securely in the place to suffi...
Installation of Battery kit (TCB-BT1UPE) • Refer to the Installation Manual of the outdoor unit for details. • Do not connect anything except TOSHIBA Battery kit. • This kit includes a nickel-metal hydride battery (NiMH). For your safety, please read Instruction Manual in Switch only the No.
• Use attached-pipe (accessory) to connect the pipe with different diameter from the pipe to Flow Selector unit. WARNING (RBM-Y1121FUPE) If refrigerant gas has leaked during the installation work, ventilate the room immediately. If the leaked refrigerant gas comes in contact with fi re, noxious gas may be generated.
ELECTRICAL CONNECTION Airtight test/Air purge, etc. For airtight test, air purge, addition of refrigerant, and gas leak check, follow the Installation Manual attached to the outdoor unit. CAUTION REQUIREMENT • If incorrect / incomplete wiring is carried out, it will cause an electrical fi re or smoke. Be sure to use the tool such as charge hose exclusive to R32 or R410A.
Page 12
Communication wiring Connecting power supply wire and communication wires • 2-core with non-polarity wire is used for wiring of the communication wiring. • Wire size : 0.5 mm² to 2.0 mm² • Up to 300 m (L1 + L2 + L3 + L4) Indoor unit Screw L...
Page 13
See the fi gure on the left for connecting wires to the terminal. Earth wire Communication wire Power supply wire Communication wires Communication wiring Terminal block for remote controller wiring of indoor unit Flow Selector unit terminal on PCB Communication wires (locally procured) EN-23 EN-24...