FLI R
ADK
1 Introduction
1.1 Revision History
Version
100
110
120
130
1.2 Reference Documents
Ref Number
1
1.3 SCOPE
This document describes detailed instructions on the conditions and requirements for
integrating the FLIR ADK with various communications methods including USB, Ethernet,
GMSL accessory board for communication, video streaming, and hardware synchronization.
1.4 BACKGROUND
The FLIR ADK comes in three variants USB output, GMSL output, and GMSL output with a
converter for GMSL to Ethernet. This document describes how to get each version up and
imaging.
2 USB – Getting Started
The USB option for the ADK ships with a Boson connected by USB for video and command
and control, a BNC cable for external sync input, and a Mizu-P25 connector to power the
window heater.
2.1 Connect and power the USB ADK
1) Connect the USB cable to the computer.
2) Optional: To power the window heater, apply 12 VDC to the MIZU-P25 connector (shown
below) to power the heater. The heater is protected against reverse polarity so it's
technically ok to hook it up in reverse, it will just pull a little more power. The red lead
Date
05/02/2019
7/9/2019
10/14/2019
11/15/2019
Document number Comments
102-2013-40
The information contained herein does not contain technology as
defined by EAR,15 CFR772, is publicly available, and therefore
not subject to EAR.
Ge tt in g S ta rt ed
Comments
Initial Release
16-bit Video + cable spec
Ethernet Description
GMSL Description + USB Description
Boson datasheet
3
Need help?
Do you have a question about the ADK and is the answer not in the manual?