Cisco IR1101 User Manual page 21

Product Overview
Prerequisite for Installing the DSL SFP
The DSL SFP will only function on IOS-XE release 17.4.1 and above.
Due to a change in the IR1101 Faceplate, older routers are not able to use the DSL SFP. There is no viewable
version on the IR1101 Faceplate, but you can determine if your router is new enough to use the DSL SFP
through the show inventory command:
IR1101#show inventory
+++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++
INFO: Please use "show license UDI" to get serial number for licensing.
+++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++
NAME: "Chassis", DESCR: "IR1101 Base Chassis"
PID: IR1101-K9
NAME: "Module 0 - Mother Board", DESCR: "Cisco IR1101 motherboard"
PID: IR1101-K9
NAME: "module subslot 0/0", DESCR: "IR1101-ES-5"
PID: IR1101-ES-5
NAME: "subslot 0/0 transceiver 0", DESCR: "GE T"
PID: SFP-VADSL2+-I
The IR1101 K9 VID version must be equal to, or greater than V05 as shown above.
DSL SFP Overview
The DSL SFP interface is an 8 pin modular jack. The following table shows the pin-out assignments:
Pin Number
1
2
3
4
5
6
7
8
The modular jack pin-outs are shown in the following graphics:
, VID: V05 , SN: FCW23500H5X
, VID: V05 , SN: FOC23473SRK
, VID: V01 , SN:
, VID: V01 , SN: MET2023000A
Pin Assignment
Not Used
Not Used
Not Used
Analog Input
Analog Input
Not Used
Not Used
Not Used
DSL SFP Overview
Product Overview
21