Mes; Ames - Vaisala PWD22/52 User Manual

USER'S GUIDE____________________________________________________________________
58 __________________________________________________________________ M210543EN-E
Command
TIME hh:mm:ss
DATE yyyy:mm:dd
WPAR
CHEC
ZERO
CAL Calibrator_frequency
CONF Password
WSET
CLEAN
BAUD Rate Commn._type
DRY ON
WET ON
ACAL
BLSC
RESET

MES

After opening the line for operator commands (see section Entering and
Exiting the Command Mode on page 49), a data message can be
displayed using the MES command. Refer to section Message Types on
page 50 for message type descriptions.
The command format is the following:
MES Message_number
The valid range is 0 ... 7.
For example, when choosing the data message number 0, type the
following:
>MES 0

AMES

The AMES command defines the message, which PWD22/52 transmits
as the automatic message or as the default polled message. Refer to
section Automatic Message Sending on page 54.
Description
Set/Display system time.
Set/Display system date.
Weather parameter message.
Displays calibrator test signal.
Displays zero and noise test status.
Calibration.
Updates configuration.
PRW reference values.
Sets clean references.
Baud rate setting
(Rate 300, 1200, 2400, 4800, 9600)
(Communication type E (7E1) or N
(8N1))
®
Sets RAINCAP dry offset.
®
Sets RAINCAP wet scale.
Analog output calibration.
Background luminance scale / enable.
Hardware reset by watchdog.