System Configuration Commands; Par; Conf - Vaisala PWD22/52 User Manual

USER'S GUIDE____________________________________________________________________
62 __________________________________________________________________ M210543EN-E

System Configuration Commands

The following command can be used to display system parameters and to
edit the current system configuration:
- PAR, Parameter message
- CONF password, Updates configuration
- BAUD rate comm. type, Sets baud rate and type (Rate 300,
1200, 2400, 4800, 9600), (Communication type E (7E1) or N
(8N1)

PAR

The current system parameters can be displayed by using the PAR
system parameters command.
The system output is the following (example for PWD22):
SYSTEM PARAMETERS
VAISALA PWD22 v 1.00 2003-04-09 SN:X1234567 ID STRING:
AUTOMATIC MESSAGE 0 INTERVAL 0
BAUD RATE: 9600 N81
ALARM LIMIT 1 0
ALARM LIMIT 2 0
ALARM LIMIT 3 0
RELAY ON DELAY 10 OFF DELAY 11
OFFSET REF 152.38
CLEAN REFERENCES
TRANSMITTER 5.0 RECEIVER 1200
CONTAMINATION WARNING LIMITS
TRANSMITTER 0.5 RECEIVER 300
CONTAMINATION ALARM LIMITS
TRANSMITTER 3.0 RECEIVER 600
SIGN SIGNAL 1 1.000
DAC MODE: EXT1
MAX VIS 20000, 20.0 mA
MIN VIS 180, 4.5 mA
20 mA SCALE_1 184.6, SC_0 -2.8
1 mA SCALE_1 184.8, SC_0 -1.4

CONF

With the CONF command, PWD22/52 asks the system parameters one
by one, showing the current value in most cases as the default. The old
settings are not changed, if users simply press ENTER as the answer.
The CONF configuration command is used to set or update system
parameters and adjust certain calibrations, reference values, and limits.