APRILIA TUONO V4 R a-PRC ABS Service Station Manual page 362

Engine
•
On the outside of the crankcase, mark
the passage of the countershaft lubri-
cation oil.
•
Sprinkle the sliding surfaces of the half
bushings with grease on the special
tool.
•
Install the new half bushings, aligning
the hole with the slot on the ring of the
special tool.
•
Install the ring on which the half bush-
ings are installed on the punch of the
special tool.
•
Place the adaptor (3) on the ring for
centring the half bushings.
•
Place the punch in the crankcase,
aligning the slot on the ring of the spe-
cial tool with the reference marked on
the crankcase exterior.
•
Place the new half bushings using the
press.
ENG - 362
TUONO V4 R a-PRC ABS