Advertisement
TUONO V4 R a-PRC ABS
1. Engine speed sensor cable routing between the
front motorised throttle body and the 3-way fitting.
2. Water temperature sensor
3. Cable harness routing (branch "4") under the 3-
way fitting
4. Rubber clamp.
TABLE G2 - WATER TEMPERATURE SENSOR
AND INJECTORS CONNECTION
•
At this point, the injectors 2 (output "5")
and 4 (output "6") can be connected:
the connector for injector 4 is GREY (or
there is a spot with grey tape on the
cable harness) whereas the connector
for injector 2 is BROWN.
•
Move the connector for coil 2 (output
"7"), marked with red tape, to the far
left, routing with the respective wiring
together with the injector cable har-
nesses.
1. Injector 4 cable harness connector (output "6")
GREY connector
2. Injector 2 cable harness connector (output "5")
BROWN connector
3. Coil 2 cable harness routing (output "7")
4. Coil 2
5. Coil 4
TABLE G3 - WATER TEMPERATURE SENSOR
AND INJECTORS CONNECTION
•
Connect the injectors 1 (output "16")
and 3 (output "17"), which are on
branch "3": the connector for injector 1
is BLACK whereas the connector for
injector 3 is GREEN (or there is a spot
with blue tape on the cable harness).
Move the cable for coil 3 to the far left,
Electrical system
ELE SYS - 131
Advertisement
