Table of Contents
Advertisement
FEMA ELECTRÓNICA . SERIES B . Models Bxx-C1
1.16 Mounting
The instrument fixations are designed to allow panel mount,
wall mount, or hanging mount. For each type of mounting,
• Panel mount. Apply the cut-out to the panel as seen on
section 1.4. Remove the side fixations. Introduce the in-
strument into the panel cut-out. Mount the side fixations
as shown (see Figure 9). Slightly loosen the fixation screw
of one side and press the instrument against the panel.
Tighten the fixation screw so it presses the panel and main-
tains the fixation. Repeat with the opposite side fixation.
For IP65 protection at the panel junction, see the IPB ac-
cessories at section 3.
Fixation screws
Side fixations
Figure 9 - Panel mount
• Hanging mount. Mount the side fixations as shown (see
Figure 10). Each fixation has 2 holes with 4,5 mm diameter
and a separation between hole centers of 30 mm. Instru-
ment can be hanged using cable, threaded rod, ....
Diameter 4,5 mm
30 mm between
hole centers
Fixation screws
Side fixations
Figure 10 - Hanging mount
28
see the position of the fixations at the images below.
• Wall mount. Mount the side fixations against the wall,
as shown (see Figure 11). Each fixation has 2 holes with
4,5 mm diameter and a separation between hole centers
of 30 mm. Once the side fixations are secured against the
wall, place the instrument and press the fixation screws
slightly. Tilt the instrument to the desired viewing angle
and firmly screw the fixation screws.
Diameter 4,5 mm
30 mm between
hole centers
Fixation screws
Side fixations
Figure 11 - Wall mount
Advertisement
Table of Contents
