Summary of Contents for Fema Electronica S40 Series
Page 1
Series S40 Panel Meters Panel meter 72x36mm size Model S40-A for TrueRMS AC Voltages for TrueRMS AC Currents Panel meter for TrueRMS measures of AC voltages and AC currents. Category of measure in CAT-III up to 300Vac and CAT-II up to 600Vac. Current measures up to 5Aac.
User’s Manual S40-A Meter S40-A Panel meter 72x36mm size for TrueRMS VAC and AAC Panel meter for TrueRMS measure of AC voltages and AC Management for up to 4 alarms with 1 or 2 setpoints each, currents. Category of measure in CAT-III up to 300Vac and with hysteresis and delays.
User’s Manual S40-A Front View Input signal connections - AC Current The current measuring has a single jumper position. Select Alarms the input range in the configuration menu. 1 2 3 4 5 Jumpers for input signal range selection. See Table 1 1 2 3 4 Range Close Jumpers...
User’s Manual S40-A Technical Data Technical Data (cont.) Digits Power Type 7 segments, red Power “H” 85 to 265 Vac/dc Height 14 mm Power “L” 11 to 60 Vdc and 24/48Vac Display maximum 9999 Consumption <4W Display minimum -1999 Isolation 3500Veff for power “H”...
User’s Manual S40-A Mechanical Dimensions (mm) Information Menu Signal Range Configuration Input Low Display Low Panel 32,5 cut-out Input High Display High Information Menu - Operation Memory of maximum Maximum To enter the “Information Menu” press the SQ button. The “Information Menu”...
User’s Manual S40-A Configuration Menu Configuration Menu - Operation To enter the “Configuration Menu” press the SQ button. The Range 600Vac “Configuration Menu” allows to change the configuration of Input the instrument. Access to the “Configuration Menu” can be Range 100Vac password protected with the function “PASSWord”.
User’s Manual S40-A Configuration Menu Setpoint2 Second setpoint Tools Password Select password See menu for Alarm1 Factory Default Resets to factory de- See menu for Alarm1 fault values See menu for Alarm1 Firmware version Version Fixed Digits Fix digits Display Minimum brightness Brightness Default brightness...
User’s Manual S40-A Setpoint (SEt) - Value from “9999” to “-1999”. Alarm set point. Input Menu Hysteresis (hySt) - Value from “0” to “9999”. Points of hyster- The input menu selects the input signal range. Options avail- esis. The hysteresis applies on the deactivation of the alarm. able are 600Vac, 100Vac, 10Vac, 1Vac, 100mVac, 5Aac and 1Aac.
User’s Manual S40-A Peak & Hold (P.hLd) - Peak & Hold function detects sharp Messages and errors drops in the displayed value, and holds the display if a display drop is detected. To disable the hold function for a moment, When the instrument detects that the displayed value does press any of the front buttons or wait for a predefined time : not correspond to the input value, the display will flash and...
User’s Manual S40-A Option R1 - 1 relay Accessing the instrument Relay type 3 contacts (Com, NC, NO) You may need to access the inside of the instrument to insert Maximum current 8A (resistive load) additional options. Use a flat screwdriver to unlock the upper Voltage 250 Vac continuously clips marked with “A”.