Table Of Contents - Husqvarna DM 650 Workshop Manual

HUSQVARNA
DM 650
T27
2
CONTENTS
1. DOCUMENTATION
2. COMPONENTS, WORK TIPS
3. DISMANTLING IN BASIC MODULES
4. GEAR HOUSING - PRIMARY SHAFT
5. GEAR HOUSING - SLIP CLUTCH
6. GEAR HOUSING - SECONDARY SHAFT
7. GEAR HOUSING - SPINDLE SHAFT
8. GEAR HOUSING - BEARING REPLACEMENT
9. MOTOR
10. ELECTRICAL COMPONENTS
11. COOLING/WET SYSTEM
12. TROUBLESHOOTING
13. TOOLS
Screws - dimensions and torques
L
Information on screw type and recommended tightening torque is
given in brackets - e.g. (M5x26, 7-8 Nm) - in a number of places
in this workshop manual.
M= standard millimetre thread for fitting in metal.
MT= coarse thread for fitting in plastic.
5x26 indicates the coarseness x the length in millimetres. Note
that the length is calculated minus the screw head.
7-8 Nm indicates the tightening torque in Newton metres.
Practically all screws of smaller dimensions have Torx T27 screw
heads.
Page
3
4
5
7
8
10
12
14
16
18
19
21
25