Husqvarna DM 650 Workshop Manual page 6

3
1
3
5
7
6
DISMANTLING BASIC MODULES
2
4
6
Division – gear housing/motor housing
1. The panel is secured with five screws. Remove these.
Lift off the panel. 5 x MT 5x14, 3–4 Nm
2. Remove the three screws to the circuit board.
3 x MT 5x20, 2–4 Nm
3. Fold down the circuit board to ensure the connectors
are accessible. Note how these are attached to the holder
when refitting.
4. Divide the connectors and release them from the
holder.
5. Remove the circuit board.
6. Remove the four screws on the machine cover.
7. Remove the two screws on the bottom of the machine.
2 x M5x16, 8 Nm
8. Release the bushings for the water hose and electric
cable from the motor housing by pushing them
upwards and out of their attachments.
9. The motor cover can now be removed by sliding it
backwards. The motor is now accessible.