Nmark SSaM Hardware Manual
2.8.2. Differential Analog Inputs (TB103 A/B)
To interface to a single-ended (non-differential) voltage source, connect the signal common of the source to
the negative input and the analog source signal to the positive input. A floating signal source should be
referenced to the analog common as shown in
Table 2-25:
Differential Analog Input Specifications (TB103 A/B)
Specification
(AI+) - (AI-)
Resolution (bits)
Resolution (volts)
1. Signals outside of this range may damage the input
For increased noise immunity, a 1K to 10K resistor can be connected across the differential analog ± inputs.
www.aerotech.com
Figure
2-15.
+10 V to -10 V
Figure 2-15:
Analog Inputs (TB103)
Chapter 2
Installation and Configuration
Value
(1)
16 bits
305 µV
39