Table of Contents
Advertisement
Revision 11/12
No. Designation
1 Base plate
2 Spacer bar
3 Load cell
4 Washer
5 Cylinder head screw
6 Ground cable
7 Hexagon head screw
8 Washer
Fig. 3-2 Construction Combi-Mounting Unit BB 350 / 500 kg
3.2
Assembly
3.2.1 Assembly Combi-Mounting Unit BB10 - 200 kg
The conditions for installation are very different. The load platform can be very low or
relatively high. It could be a container, a platform or a conveyor for example. The
following assembly instructions can only be taken as general guidelines.
WARNING
Proper tools are to be used for lifting the load platform. Ensure that the respective
safety regulations are followed.
The load platform should always be built on dummies to begin with, so that the load cells
are protected from damages during assembly. The load platform must then only be lifted
a few millimeters from bracket to bracket to position the combi-mounting unit. The
following description of assembly is based on this situation.
Document-No.: A5E00295975A
Combi-Mounting Units
No.
Designation
9 Pressure piece load cell
10 Ball
11 Pressure piece head plate
12 Head plate
13 Nut
14 Washer
15 Countersunk screw
Page 28
Advertisement
Table of Contents
