Hydraulic Connections - baltur RINOX 190 L2 Manual Instructions For Use

HYDRAULIC CONNECTIONS

The pipes that connect the tank tothe burner should be in perfect tight condition; we recommend the use of copper or steel pipes of an
adeguate diameter.Fuel gate valves should be fitted at the end of the rigid pipelines.Fit the filter to the suction pipeline after the gate
valve. Connect the flexible fitting to this, which in turn should be connected to the suction of the burner pump. Connect the flexible fitting
to the return pipe after the gate valve, and then connect it ot the pump return. Filter, flexible pipes and relative connecion nipples are
standard burner accessories. The pump is provided with special connection points for the insertion of control instruments (manometer
and vacuumeter).To ensure reliable and silent operating conditions, the vacuum in suction should not exceed 35 cm Hg equal to 0,46 bar.
Maximun suction and return pressure 1,5 bar.
GRAVITY FEED FROM THE BOTTOM OF OIL TANK
GRAVITY FEED OVER THE TOP OF OIL TANK
SUCTION FEED
N.B. For any missing devices in the
pipping, conform to existing regula-
tions.
H = Measurement between minimum oil level and pump axis
L = Max. legth of suction line, including vertical lifts. For each bend of valve deduct 0,25 m.
Ø i = Internal diameter of pipe
6 / 16
0006080951_201401
1 Oil tank 6 Suction line
2 Feed line 7 Return line
3 Filter 8 Fire valve
4 Burner 9 Non return valve
5 Degasifier
H
meters
1
2
3
4
1 Oil tank 7
3 Filter 8
4 Burner 9
6 Suction line 10 Foot valve
H
meters
1
2
3
4
1 Oil tank 6
3 Filter 7
4 Burner 10 Foot valve
H
meters Ø i. 10 mm.
0,5
1
1,5
2
2,5
3
3,5
N° 0002900860
REV.: 27/07/99
Total meters
Ø i. 10 mm.
30
35
40
45
Return line
Fire valve
Non return valve
Total meters
Ø i. 10 mm.
30
35
40
45
Quote P = 3,5 m (max)
Suction line
Return line
"L. Total meters"
Ø i. 12 mm.
26 54
24 47
18 38
14 30
10 23
6 15
- 7