Establishing A Connection To The Engineering Pc Via The Usb Device Interface "Xf31 - Bosch rexroth IndraControl XM21 Operating Instructions Manual

IndraControl XM21, XM22 Controls
1. Mount the control.
For details, refer to
lation" on page
2. Connect the voltage supply to the XD1 connection of the control.
Refer to chapter 10.7.2 "Voltage supply for the control" on page
3. Switch on the XM2x control. The initial firmware starts
For more information on how to commission the XM2x control with the ini-
tial firmware, refer to
NOTICE
Note that hardware is initialized after switching on the control and after instal-
ling the system firmware with subsequent reboot. An internally programmable
function block is loaded. After loading, the LED display "ON" at the voltage plug
is green. Otherwise, the LED display "ON" is red. If the LED display "ON" is red,
trigger a fallback (see
perform this step again.
Wait till completion. Do not switch off the control. This procedure has to be
completed. Subsequently, continue the commissioning.
11.2 Establishing a connection to the engineering PC via the USB
device interface "XF31"
Instead of using the Ethernet interface "XF5" to commission the control or to
use the commissioning tool "IndraControl First Touch", use the connection XF31.
Connect the USB interface of your computer to the USB device connection
"XF31" via a common USB data or charging cable. Upon the initial connection,
the respective device driver (USB Remote NDIS) is installed on the PC.
Even though the computer and the control communicate via Ethernet, it is only a
point-to-point connection.
The connection to the engineering PC using the USB device interface
"XF31" performs significantly less well than the engineering interface
"XF5". The interface "XF31" is suitable for commissioning and diag-
nostic purposes. Use the engineering interface "XF5" for a strong da-
ta transfer task (e.g. monitoring).
The IP address of the connection "XF31" on the control is
192.168.234.234.
The IP address cannot be changed.
If the RNDIS device driver is not installed automatically, install it manually:
chapter 10 "Mounting, demounting and electric instal-
16.
chapter 12.2 "XM2x initial firmware" on page
Control malfunction due to control switch-off
during initialization
chapter 12.5 "Fallback and recovery" on page
R911340667_Edition 04 Bosch Rexroth AG
31/69
Commissioning
26.
39.
54) and