Table of Contents
Advertisement
CL3300 Series
Cylindrical Lockset
Installation Instructions
3
Cylinder Installation
a
CL3355 Classroom or CL3352 Intruder (Outside Cylinder) Function Timing
Before installing cylinder:
• Turn cam so points are up and down,
6 o'clock and 12 o'clock. (Figure 6)
After installing cylinder:
• Confirm key rotates 180° both ways.
• If cylinder rotates 360°, remove cylinder and
check cam orientation.
b
Interchangeable Core Installation
1. Install tailpiece. (Figure 7)
2. Insert key marked CONTROL and turn clockwise
approximately 15°. (Figure 8)
3. Insert core into lever and return key to its original
horizontal position locking core in place. (Figure 9)
4. Withdraw key.
5. Test lockset for correct function with operating key.
6. Control key has no further use in lockset installation and
must be safeguarded for return to security personnel
when installation is complete.
Control Key
Core
For installation assistance contact Corbin Russwin
1-800-543-3658 • techsupport.corbinrusswin@assaabloy.com
Copyright © 2012, 2020 ASSA ABLOY Access and Egress Hardware Group, Inc. All rights reserved. Reproduction in whole
or in part without the express written permission of ASSA ABLOY Access and Egress Hardware Group, Inc. is prohibited.
Interchangeable Core
Lever Assembly
Figure 8
Cam
Lever Catch
Control Key
Figure 9
12
9
3
9
6
Correct
Figure 6
Tailpiece
Tailpiece
Security Disc**
Corbin
Russwin
Spacer
Core
(Used with
6-pin Core only)
Small Format Core 6- or 7-pin
Tailpiece with
retaining ring
oriented for Primus
Schlage
Core
®
Figure 7
4
12
3
6
Wrong
** Verify that
security disc
is installed
for either
6-pin or
7-pin Corbin
Russwin or
small format
cores.
Tailpiece with
retaining ring
oriented for all
Schlage cores
except Primus
FM533 02/20
Advertisement
Table of Contents
