Table of Contents
Advertisement
Installation
6
Installation
Observe the safety instructions in Ch. Safety, from page 5 on.
Information on tightening torques for screws and cross-sections for hoses
Technical data
can be found in Ch. Technical data, from page 8 on.
Procedure
When installing the VAC, carry out the following steps in succession:
Adapter plate
Some vibrators require an adapter plate for mounting on certain types of
VAC (see Ch. Technical data, page 9).
Adapter plates with matching bores are available on request.
VAC 6
Mount the approved vibrator as follows:
Example: NTS
1.
2.
3.
16
Determine and mark the required bores using the following template.
Common hole spacings are marked.
Drill tapped blind holes from above into the gound plate (2). The di-
ameter of the through-holes (x) that is necessary for the vibrator can
be found in the table for the template.
Mount the vibrator (3) with setscrews according to DIN 913 (G; for
NTS) or hexagon bolts according to DIN 933 (S; for NTP and NCT).
Use suitable screw lockings.
IMPORTANT
Example: NTP
1
Suction cup
2
Ground plate of VAC
3
Vibrator
G
Setscrew
S
Hexagon bolt
Advertisement
Table of Contents
