RH Baby&child JAMESON Assembly Instructions Manual

Toddler bed conversion kit

Advertisement

1/7
1 1 /

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the JAMESON and is the answer not in the manual?

Questions and answers

Summary of Contents for RH Baby&child JAMESON

  • Page 1 1 1 /...
  • Page 2 IMPORTANT SAFETY INFORMATION FOR TODDLER & DAY BEDS WARNING: ENTRAPMENT / STRANGULATION HAZARD Infants have died in toddler beds from entrapment and strangulation. Failure to follow these warnings and the assembly instructions could result in serious injury or death. NEVER use bed with children under 15 months. NEVER place bed near windows where cords from blinds or drapes may strangle a child.
  • Page 3 · We do not recommend the use of chemical cleaners, abrasives, or furniture polish on our lacquered finish. PART LIST JAMESON CONVERSION HEADBOARD JAMESON CONERSION SIDE RAIL PANELS JAMESON CONVERSION TODDLER BED KIT MATTRESS SUPPORT TODDLER CONVERSION KIT ASSEMBLY HARDWARE IS INCLUDED IN THE TODDLER KIT BOX.
  • Page 4 ASSEMBLY INSTRUCTIONS STEP 1 FRONT RAIL PANEL DISASSEMBLY DETAIL A STEP 1.1 Remove the front rail panel of the crib by loosening all the bolts installed, as in DETAIL A. STEP 1.2 Gently tilt the crib and release the bolts underneath the metal brackets holding the stabilizer rails, as in DETAIL B.
  • Page 5 STEP 2 TODDLER RAIL ASSEMBLY DETAIL C STEP 2.1 On inside face of both side rail panels there is a cavity for the hook Plain washer and a hole for the Allen bolt to pass through which corresponds to Lock washer the hooks on both ends of the toddler rails and holes with pre-installed nuts.
  • Page 6 STEP 3 MATTRESS SUPPORT HEIGHT ADJUSTMENT DETAIL D NOTE: If mattress supports is not in the lowest position. STEP 3.1 Loosen and remove all hardware (BB) on both sides of the frame of mattress support. STEP 3.2 Re-install the bolt on the third hole of the frame through the hole on the arm support.
  • Page 7 STEP 4 INSTALLATION OF STABILIZER RAILS INTO THE SIDE PANEL STEP 4.1 DETAIL F On inside face of both side rail panels are pre-installed metal brackets, designed to hold the stabilizer rails. Set both ends of the stabilizer rails into brackets, as illustrated in DETAIL F. STEP 4.2 Once the stabilizer rails are set, gently tilt the toddler bed and fasten the stabilizer rails with bolt, plain washer and lock...

Table of Contents