Key Features; Onboard Ide - QDI WinneX 3 Manual

Introduction

Key Features

Form factor
MicroATX form factor of 244mm x 188mm.
l
Microprocessor
®
Supports Intel Pentium
l
100MHz bus speed.
®
Supports Intel Pentium
l
66MHz bus speed.
®
Supports Intel Pentium II
l
100MHz bus speed.
®
Supports Intel Celeron
l
processors with 66MHz bus speed.
Supports 66/100MHz host bus speed.
l
The CPU core voltage adjustable from 1.3V to 3.5V automatically through onboard
l
switching voltage regulator with VID(Voltage ID).
Provides onboard 1.5V, 1.8V, 2.5V and 3.3V standby regulator.
l
System memory
Provides two 168 pin 3.3V unbuffered DIMM sockets.
l
Supports 64-bit wide DIMM modules with 100MHz SDRAM devices.
l
Supports 8MB to 512MB SDRAM using 16Mb/64Mb technology.
l
Supports 512MB SDRAM using 128Mb technology.
l
Supports suspend to RAM.
l

Onboard IDE

Supports two PCI PIO and Bus Master IDE ports.
l
Two fast IDE interfaces supporting four IDE devices including IDE hard disks and
l
CD-ROM drives.
Supports up to PIO Mode 4 timing.
l
Supports "Ultra ATA/33" Synchronous DMA modes, transferring data up to 33MB/s.
l
Supports "Ultra ATA/66" Synchronous DMA modes, transferring data up to 66MB/s.
l
®
(for Intel 810 and Intel
Integrated 16x32bit buffer for IDE PCI Burst Transfers.
l
Onboard I/O
Winbond W83627HF LPC I/O chip.
l
One floppy port supporting up to two 3.5" or 5.25" floppy drives with 360K/720K/
l
1.2M/1.44M/2.88M format.
Two high speed 16550 compatible UART (COM1/COM2/COM3/COM4 selective) with
l
16-byte send/receive FIFOs.
2
®
III Processors at 450MHz and future processors with
®
II Processors at 233/266/300/333MHz processors with
®
Processors at 300/350/400/450MHz processors with
TM
Slot1 Processors at 266/300/333/366MHz and future
®
810 DC-100 only)
Manual for WinneX 3