Rack Mounting Merging Unit Into Combiflex 19" Equipment Frame (Type Rhgt 19" 4U Variant C) - ABB SMU615 Installation Manual

Section 4
Mounting
4.3.8
32
GUID-D34180CA-1F3F-4F72-98CF-BFAD53DE4502 V1 EN
Figure 22: Merging unit and the test switch RTXP 18 mounted into a 19"
equipment panel
Rack mounting merging unit into combiflex 19" equipment
frame (Type RHGT 19" 4U variant C)
A mounting bracket is needed for rack mounting the merging unit into a combiflex 19"
equipment frame, a different bracket is in installation with test switch. In addition to
the detailed mounting instructions, the mounting kit includes:
• Mounting bracket for the case and optionally with RTXP test switch
1. Install the mounting bracket into the combiflex equipment frame by using
tapping screws ST3.5x13 from rear side.
The type of mounting bracket to be used depends on whether the
merging unit is installed into the frame on its own or with a test
switch.
2. Loosen the four M5 fixing screws in the case to fit the case into the mounting
bracket.
3. Mount the case to the mounting bracket.
1MRS758405 C
SMU615
Installation Manual