Canon LASER CLASS 730i Service Manual page 293

b-6) Removing the kit
When removing the kit, perform the steps in b-4) Attaching to the main unit in reverse
order. Be sure to remove the kit only after turning the power off.
3.8.3 Technical information
a) Specifications
Interface
CPU
Protocol
3.8.4 Maintenance and service
a) Troubleshooting
The fax does not recognize the Network Kit III even when it is attached
properly.
Solutions: (1) Check that the kit is securely connected.
(2) Replace the kit.
(3) Replace the SCNT board.
LASER CLASS 730i/720i/710 Chapter 5: Appendix
10Base-T, 100Base-TX
RISC CPU (100 MHz)
IPX/SPX, PServer, NDS PServer, NDPS, LPD, Port9100, NetBIOS
IPP, PAP (Apple Talk Printer Access Protocol)
5-85