Canon LASER CLASS 730i Service Manual page 278

LASER CLASS 730i/720i/710 Chapter 5: Appendix
b-4) Attaching to the main unit
(1) When attaching the PCL unit, check to make sure that the core of the 10-pin cable must
be placed between the backside of the PCL unit and the cable clip. (Do not place the
core on the PCL unit board surface) After that, secure the PCL unit with six screws.
(2) Connect the flat cable to the connector J5 of the PCL board.
(3) Connect the 10-pin cable to the connector J6 of the PCL board, and then secure it in
place using clamp.
Screws
PCL unit Screws
Figure 5-78 Printer Kit III Installation 1
Connector J6 Clamp
Connector J5
Figure 5-79 Printer Kit III Installation 2
5-70
PCL board
manuals4you.com manuals4you.com