Belt Clip Installation; Headset Connection - Yaesu FTA-750L Spirit Operating Manual

Belt Clip Installation

You may mount the clip to the rear of the FTA-750L/
FTA-550/FTA-450L using the supplied screws.
D A
T A
E X
T
D C
18
Before You Begin
SHB-11
Belt Clip
with two screws (M3 x 8)

Headset Connection

You may use an optional headset through the supplied
SCU-42 Headset Adapter Cable (see also Page 89).
SCU-42
*Please purchase an aftermarket PTT switch.
1. Remove the cover and two screws of the MIC/SP
jack located on the right side of the transceiver.
2. Insert the plug of the SCU-42 to the MIC/SP jack.
3. Fix the plug with two screws attached to the SCU-
42.
 Either of the plug directions are acceptable as
long as the both screws fit the screw holes.
4. Insert the plugs of the headset to the sockets of the
SCU-42.
Headset
(not supplied)
Speaker
Microphone
PTT switch*
(not supplied)