Battery Charging - Yaesu FTA-750L Spirit Operating Manual

Battery Charging

It is necessary to charge the Lithium-ion battery fully
before its first use. Follow the procedure below:
1. Install the Lithium-ion battery pack onto the trans-
ceiver. Ensure that the transceiver is switched off.
2. Insert the cable plug of the SAD-25 Battery Char-
ger into the jack located on the back of the SBH-11
Charging Cradle, then plug the SAD-25 into the AC
line outlet.
T A
D A
T
E X
D C
SBH-11
3. Insert the transceiver into the SBH-11; the antenna
jack should be at the left side when viewing the
cradle from the front.
Before You Begin
 You may insert the cable plug of the SAD-25
4. If the transceiver is inserted correctly, the RED indi-
cator on the SBH-11 will glow.
 A fully-discharged pack will be charged com-
 It takes 10 hours for full charge with the SAD-
Important Notes:
 The SAD-25 is not designed to power the transceiv-
er for operation (transmission).
 Do not leave the charger connected to the transceiver
SAD-25
for continuous periods in excess of 24 hours. Long
term overcharging can degrade the Lithium-ion bat-
tery pack and significantly shorten its useful life.
 If using a charger other than the SAD-25, SBH-11,
or if using a battery pack other than the SBR-39LI,
follow the appropriate instructions provided with the
charger/battery. Contact your Dealer if you have any
doubts about the appropriateness of the particular
charger or battery pack you intend to use.
into the EXT DC jack located on the right side of
the transceiver directly. In this case, the "
icon will appear in the top right corner of the
LCD display.
pletely in 5.5 hours, and then the GREEN indica-
tor on the SBH-11 will glow.
25 connected to the transceiver directly.
"
15